Kimberley – Kichler 300008 User Manual

Page 7

Kimberley

Fig. 13

Fig. 14

Fig. 15

An additional safety support is provided to
prevent the fan from falling. Secure the safety
cable to the ceiling joist with screw and
washer, as illustrated in Figure 13.

7. MAKE THE ELECTRIC CONNECTIONS

WARNING: To avoid possible electrical shock,
be sure electricity is turned off at the main fuse
box before wiring.

NOTE: The CoolTouch

control system is

equipped with 16 code combinations to prevent
possible interference from or to other remote
units. The frequency switches on your receiver
and transmitter have been preset at the factory.
Please recheck to make sure the switches on
transmitter and receiver are set to the same
position, any combination of settings will
operate the fan as long as the transmitter and
receiver are set to the same position. (Fig. 14)

Step 1. (Fig. 15) Insert the receiver into the
mounting bracket with the flat side of the
receiver facing the ceiling.

Step 2. (Fig. 16) Motor to receiver electrical
connections: Connect the black wire from the
fan to black wire marked "TO MOTOR L".
Connect the white wire from the fan to the
white wire marked "TO MOTOR N" from the
receiver. Connect the blue wire from the fan to
the blue wire marked "For bottom Light" from
the receiver. Connect the orange wire from fan
to the orange wire from receiver marked "For
Upper Light". Secure wire connections with the
plastic wire nuts provided.

Hanger bracket

Safety cable

Code switch

Receiver

Hanger
bracket

6. INSTALLATION OF SAFETY SUPPORT

(for Canadian Installation ONLY)