Kichler 300008 - Manual (Page 10)

9
Fig. 20
Fig. 21
12. INSTALLING THE LIGHT BULBS
& GLASS SHADE
NOTE: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box.
Step 1. Loosen the 3 screws from the
mounting plate.
Step 2. Raise and hold the light kit close to the
mounting plate. Connect the white wire
connectors from the light kit and fan. Follow
the same procedure with the black wire
connectors. (Fig. 20)
Step 3. Tuck connections neatly into mounting
plate, Place the light kit key holes over the 3
screws previously loosened from the mounting
plate, turn light kit until it locks in place at the
narrow section of the key holes. secure by
tightening the 3 screws previously loosened.
(Fig. 20)
1. Install 3 x 40W candelabra bulbs (not
included).
2. Remove the decorative nut and metal nut
from the light kit. Place glass shade over the
light kit stem, secure with the metal nut (rubber
side on the top) and decorative nut. Do not
overtighten. (Fig. 21)
3. Restore power and your light kit is ready for
operation.
11. INSTALLING THE LIGHT KIT
Light kit
Bulbs
Glass shade
Decorative nut
Metal nut
Mounting plate
Connection plugs
Light kit
Screws