Kichler 300008 - Manual (Page 13)

12
Kimberley
TM
Fig. 26
Fig. 27
15. INSTALLING THE COOLTOUCH TM
CONTROL SYSTEM WALL PLATE
To install the CoolTouch TM control system wall
plate, you can select the following locations to
fulfill your wall plate installation:
1. Using the existing wall outlet box:
Step 1. Remove the existing wall plate and the
old switch from the wall outlet box. Wire nut
the BLACK leads (hot) together and push back
inside the outlet box. (Fig. 26)
Step 2. Install the CoolTouch TM wall plate to the
existing wall outlet box with 2 screws provided.
(Fig. 27)
2. Install on flat wall:
Place the CoolTouch TM wall plate on a flat wall
using the wall anchors and 2 wood screws
provided.
16. IINSTALLING THE TRANSMITTER
1. To place the transmitter in the wall plate, put
the bottom end in first and then press the top
into the wall plate. The transmitter is now held
in the wall plate and will function from here.
(Fig. 28)
2. To remove the transmitter from the wall
plate, push the release button and the
transmitter will fall into your hand.
Screws
Wal l p l at e
Sw i t c h
Ou t l et b o x
CoolTouch TM wall plate
Ou t l et b o x
Release
button
Fig. 28