beautypg.com

Turning the projector on/off, Connecting the power cord, Turning the projector on – Eiki EIP-1500T User Manual

Page 31: Turning the power off

background image

28

Turning the Projector On/Off

Info

• English is the factory preset language. If you want to

change the on-screen display to another language,
change the language according to the procedure on
page 52.

Lamp
indicator

Power indicator

STANDBY-ON button

Lens cap

ON button

STANDBY
button

On-screen Display

Info

• Do not unplug the power cord during projection or cool-

ing fan operation. The cooling fan in this projector contin-
ues to run for about 90 seconds after the projector enters
the standby mode. This can cause damage due to rise in
internal temperature, as the cooling fan also stops.

Power cord

Supplied
accessory

Connecting the Power Cord

Plug the supplied power cord into the
AC socket.

Turning the Projector On

Before performing the steps in this section,
connect any equipment that you use with the
projector. (See pages 19-27.)

Remove the lens cap and press

on

the projector or

on the remote control.

• The power indicator illuminates red.
• After the lamp indicator illuminates, the projec-

tor is ready to start operation.

Note

• The lamp indicator illuminates or blinks, in-

dicating the status of the lamp.

Green:The lamp is ready.
Blinking green: The lamp is warming up

or shutting down.

Red: The lamp is shut down abnormally or

the lamp should be replaced.

• When switching on the projector, a slight flicker-

ing of the image may be experienced within the
first minute after the lamp has been illuminated.
This is normal operation as the lamp’s control
circuitry is stabilizing the lamp output charac-
teristics. This does not indicate malfunction.

• If the projector is put into standby mode and

immediately turned on again, the lamp may
take some time to illuminate.

Turning the Power Off

(Put-

ting the Projector into Standby Mode)

1

Press

on the projector or

on the remote control, then press
that button again while the confir-
mation message is displayed, to
put the projector into standby
mode.

2

Unplug the power cord from the AC
outlet after the cooling fan stops.

EIP-1500T_E_P28_35.p65

5/22/05, 5:55 PM

28