Epson 51c - Manual (Page 28)

2
Using the Projector 23
Using the Projector
Once you’ve connected the projector to your computer or other
equipment (as described in Chapter 1), you’re ready to turn on the
projector, adjust the image, and give your presentation. This chapter
covers the following:
■ Turning on the projector and other equipment
■ Adjusting your image
■ Using the remote control
■ Controlling audio and video
■ Highlighting your presentation
■ Shutting down the projector and other equipment
Turning On Your Equipment
Make sure your projector and other equipment are set up and
connected correctly, as described in Chapter 1. Then plug in and turn
on your equipment, as described below.
Follow these steps to plug in and turn on your equipment:
1. If you’re projecting video,
first plug in and turn on
your VCR, DVD player, or
other video source. (If
you’re projecting from a
computer, go to step 2.)
2. To turn on the projector,
first connect one end of the power cord to the projector’s power
inlet on its left side.
note
If you have more than one
source connected, you may
have to switch to the one you
want to use, as described on
page 25.