Electrolux 64570 Vi - Manual (Page 23)

23
Switching off the dishwasher
If the acoustic signal has been enabled, a continuous tone will sound
for approx. 15 seconds at the end of the dishwashing cycle.
1
Carefully open the door. Hot steam may escape.
Hot dishes are sensitive to knocks. Therefore leave the dishes to cool for
about 15 minutes before removing them. You also get a better drying
result.
1. Press the ON/OFF button. All display indicators will go out.
2. Turn off the water tap.
3
If the dishwasher is not switched off, then the acoustic signal is repeat-
ed after 3 minutes and after 6 minutes.
Removing the Dishes
3
It is normal for the inner door and the dispensers to be damp.
• Empty the lower basket first, then the upper basket. This way you
avoid dripping water from the upper basket onto dishes in the lower
basket.
Care and cleaning
1
Do not use furniture care products or aggressive cleaners.
• When necessary, clean the dishwasher’s controls with a soft cloth.
• Occasionally check the internal dispensers, door seal and water inlet
filter (if fitted) for dirt and clean them, if necessary.
Polished chromium steel surfaces
Remove light dirt with a clean, damp, soft cloth – microfibre cloths are
particularly good.
1
When cleaning ensure that you do not go against the direction of the
stainless steel finish (the fine horizontal lines).
No circular movements!
Alulook surfaces
Remove light dirt with a clean, damp, soft cloth – microfibre cloths are
particularly good.
Agents that scratch or scour are not suitable.
If required, use a commercially available cleaner for chrome surfaces.
Follow the manufacturer’s instructions when using this cleaner.