Eureka 4700 Series - Manual (Page 12)

12
ENGLISH
HOW TO ASSEMBLE
(continued)
Step 7: Then wrap the hose up and over the hose hook on the handle
●
G as
shown. Plug the end of the hose into the hose retainer hole on the
base
●
E (FIG. 7a) and then snap the hose into the hose holder on
the tool caddy
●
H (FIG. 7b).
FIG. 7
FIG. 8
FIG. 9
FIG. 7b
FIG. 7a
●
F
●
G
●
H
●
E
FIG. 8a
●
B
●
A
●
C
Step 8: Place the dust cup
●
F on the vacuum by aligning the bottom
groove of the dust cup against the tab on cleaner base. Pivot the
dust cup up against cleaner and push to secure as it snaps into
place (FIG. 8).
Step 8A: (in some models only). Place Power Paw™ stair brush in slot in
the special handle holder (FIG. 8).
Step 9: Place the wand/crevice
●
A /
●
B tool in the wand holder on the
side of the vacuum. Store the dusting brush
●
C on the brush
holder on the back of the handle (FIG. 9).
Note: Screws must be installed to properly secure the parts of the vacuum.