Enviro Cara - Manual (Page 10)

10
Figure 9: Install the Rock Set Burner to the Firebox.
Maintenance And Service
R
ePLacing the
g
Lass
:
IMPORTANT: Do not operate with the glass front removed, cracked or broken. The glass in the
fireplace is a high temperature ceramic. If the glass is damaged in any way, a factory replacement door
is required (see P
arts
L
ist
). Wear gloves when handling the damaged glass door assembly to prevent
personal injury. When the glass door assembly is being transported, it must be wrapped in newsprint and
tape and/or a strong plastic bag. Removal and replacement of the glass from the door must be done by
a licensed or qualified service person. The door assembly must be purchased from an ENVIRO dealer.
No substitute materials are allowed.
c
Leaning
t
he
f
iRebox
:
With the fireplace at room temperature, carefully remove the logs. Gently remove the ceramic burner
and place on a paper towel. Vacuum the bottom of the firebox thoroughly. Carefully clean any dust off
the logs and remove any lint from the burner and pilot. At this time, inspect the burner pan for cracking
or severe warping. If a problem is suspected, contact the dealer. Check the logs for deterioration or large
amounts of soot; a small amount on the bottom side of the logs is normal. Replace the logs as in the L
og
s
et
i
nstaLLation
section.
b
uRneR
R
emovaL
& i
nstaLLation
:
IMPORTANT: Ensure the unit is off and at room temperature.
To remove the burner:
1. Remove the glass door as shown in the M
aintenance and
s
ervice
- g
Lass
d
oor
r
eMovaL
.
2. Carefully remove the log set.
3. Slide the burner back just far enough so the front edge of the burner does not catch on the front lip
of the firebox.
4. Lift the front of the burner up and out of the firebox.
Figure 8: Install the Log Set Burner to the Firebox.