Powerplus POWXG9002 HIGH PRESSURE CLEANER 2100W EN - Manual (Page 7)

POWXG9002
EN
Copyright © 2010 VARO P a g e | 7 www.varo.com
key)
5. Filter
ATTENTION :Please
make sure the filter is
inserted in the water
inlet before installing a
connector.
The inlet filter must
always be fitted inside
the water inlet to filter
out sand, limestone and
other impurities as they
will damage the pump
valves.
Caution ! Your
guarantee becomes
void if you fail to insert
the filter.
Screw the connector
onto the water inlet by
hand. (do not use tools)
6. Connect the water supply hose to the connector. (The water supply hose is not provided
in the pack.)
7. Open the water supply, make sure that the tap is fully open. WARNING: The temperature
of the incoming water must not exceed 40
℃.
8 OPERATION
Connect the water and power supply. Make sure the water supply is open. Bleed the gun by
pushing the trigger. When all air has vanished from the pressure hose (water runs out
continuosly) you can switch on the power switch of the HPC. Your High pressure cleaner is
now ready for operation.
8.1 Adjustable lance.
The lance has an
adjustable nozzle to
allow you to vary the
width of the spray. To
adjust the width of the
spray, move the
nozzle as shown in fig
7
Wide spray
Tight Beam
Turn
Turn