Assembly – Powerplus POWXG9002 HIGH PRESSURE CLEANER 2100W EN User Manual

Page 5

POWXG9002

P a g e

| 5

www.varo.com

 If an extension cord is used, the plug and socket must be of watertight construction.
 If the supply cord is damaged, it must be replaced by a qualified person in order to avoid a

hazard.

 To avoid the risk of injury, close supervision is necessary when a product is used near

children

 Know how to stop the product and release pressure quickly, be thoroughly familiar with the

controls.

 Stay alert - watch what you are doing.
 Do not operate the product when fatigued or under the influence of alcohol or drugs.
 Keep operating area clear of all persons.
 Do not overreach or stand on unstable support. Keep good footing and balance at all times.
 Follow the maintenance instructions specified in the manual.
 Always wear protective clothing and safety glasses. Loose particles and other debris may

be propelled at high speed by the water jet. Wear ear protectors.

 Do not use the cleaner in the rain. Avoid to spray water on the machine to avoid damage of

the insulation.

 Keep the power wires away from any heat source, sharp knife etc. to avoid any damage.
 Never insert or pull up the plug with wet hand, Do not pull the HPC by its cable
 Keep this machine away from concentrated acid, dissolvent and flammable, explosive

materials such as hot oil, petrol and acetone etc.

 Never jam the gun trigger in position during operation.
 There is no adjustable safety valve , when the water pressure is enough, the safety valve

will be opened automatically

7 ASSEMBLY

Attention: Make sure that the high pressure cleaner is switched off and disconnected from the
mains supply.