Powerplus POWX07551T MITRE SAW 1400W - 190MM EN - Manual (Page 13)

POWX07551T
EN
Copyright © 2014 VARO P a g e | 13 www.varo.com
 Recheck the blade depth by moving the cutting head front to back through the full motion
of a typical cut along the control arm.
8.16 Maximum cutting depth (Fig. 19)
The maximum depth travel of the cutting head was set at the factory. Check to see that the blade
does not extend more than 1/4 in. below the table insert, and does not touch the control arm
throat or any part of the base or table. If the maximum depth needs readjusting:
 Loosen the bolts of the stop plate (2).
 Move the cutting head down until the blade extends just 1/4 in. below the table insert.
 Adjust the stop place to touch the bottom of the stop knob (1) when the stop knob is raised
fully.
 Recheck the blade depth by moving the cutting head front to back through the full motion
of a cut along the control arm. If the blade touches the inside of the control arm, readjust
the setting.
8.17 The laser guide (Fig. 20)
WARNING! For your own safety, never connect the plug to a power source
outlet until all the adjustment steps are complete and you have read and
understood the safety and operational instructions.
Your tool is equipped with a laser guide using a Class IIIa laser beam. The laser beam will
enable you to preview the saw blade path on the workpiece to be cut before starting the mitre
saw. This laser guide is powered by two AAA 1.5 volt batteries.

To turn laser on, press on/off rocker switch (1) to “ON” position.
 To turn laser off, press on/off rocker switch to “OFF” position.
NOTE: All the adjustments for the operation of this laser guide have been
completed at the factory. Laser guide is calibrated and set up to project to
the right of the blade.
WARNING! Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
WARNING! The use of optical instruments with this product will increase
eye hazard. Do not attempt to repair or disassemble the laser. If unqualified
persons attempt to repair this laser product, serious injury may result. Any
repair required on this laser product should be performed by authorized
service center personnel.
9 OPERATION
9.1 Basic saw operations
9.1.1 Turning the laser guide on (Fig. 21)
Press the on/off rocker switch (1) to “ON” position to activate the laser guide.