Powerplus POWX07551T MITRE SAW 1400W - 190MM EN - Manual (Page 10)

POWX07551T
EN
Copyright © 2014 VARO P a g e | 10 www.varo.com
8.10 Mounting mitre saw stand (FIG. B)
1. Big flat washer Ø8
2. Nut M6
3. Foot stand (down)
4. Foot stand (upper)
5. Side plate of foot stand (down)
6. Side plate (long) of foot stand (upper)
7. Side plate (short) of foot stand
(upper)
8. Cross arm of foot stand (down)
9. Blot M6x10
10. Screw M8x50
11. Foot pad
12. Nut M8
8.11 Removing and installing the blade (Fig. 11, 12, 13)
WARNING! Only use a 7-1/4 in. diameter blade. To avoid injury from an
accidental start, make sure the switch is in the OFF position and the plug is
not connected to the power source outlet.
8.11.1 Removing blade
 Unplug the saw from the outlet.
 Allow the mitre saw cutting head to rise to the upright position. Raise the lower blade
guard (1) to the up position.
 Loosen the cover plate screw (2) with a Phillips screwdriver.
NOTE: Do not remove this screw.
 Rotate the cover plate (3) upward to expose the arbor bolt (4).
 Place the blade wrench over the arbor bolt.
 Locate the arbor lock button (5) on the back of the motor, below the mitre saw switch
handle. (Fig. 12)
 Press the arbor lock button, holding it in firmly while turning the blade wrench clockwise.
The arbor lock will engage after turning the wrench. Continue to hold the arbor lock button
to keep it engaged, while turning the wrench clockwise to loosen the arbor bolt.
 Remove the arbor bolt (4), the blade collar (6) and the blade (7). Do not remove the inner
blade collar. (Fig. 13)
NOTE: Pay attention to the pieces removed, noting their position and
direction they face. Wipe the blade collar clean of any sawdust before
installing a new blade.
8.11.2 Installing blade
 Unplug the mitre saw before changing/installing the blade.
 Install a 7-1/4 in. blade with a 5/8 in. arbor, making sure the rotation arrow on the blade
matches the clockwise rotation arrow on the upper guard.
 Place the blade collar (6) against the blade and on the arbor. Thread the arbor bolt (4)
onto the arbor (Fig. 13) in a counterclockwise direction.
IMPORTANT: Make sure the flats of the blade collars are engaged with the
flats on the arbor shaft. Also, the flat side of the blade collar must be placed
against the blade.
 Place the blade wrench on the arbor bolt.