Powerplus POWX07551T MITRE SAW 1400W - 190MM EN - Manual (Page 11)

POWX07551T
EN
Copyright © 2014 VARO P a g e | 11 www.varo.com
 Press the arbor lock button (5), holding it in firmly while turning the blade
counterclockwise. When arbor lock engages, continue to press it in while tightening the
arbor bolt securely. (Fig. 12)
 Rotate the cover plate (3) back to its original position until the slot in the cover plate
engages with the cover plate screw (2). While holding the lower blade guard, tighten the
screw with a Phillips screwdriver. (Fig. 11)
NOTE: The lower blade guard must be raised to the upright position to
access the cover plate screw.
 Lower the blade guard (1) and verify that the operation of the guard does not bind or stick.
(Fig. 11)
 Be sure the arbor lock is released so the blade turns freely before operating the saw.
WARNING! 1) To avoid injury, never use the saw without the cover plate
securely in place. It keeps the arbor bolt from falling out if it accidentally
loosens and helps prevent the spinning blade from coming off the saw. 2)
Make sure the collars are clean and properly arranged. Lower the blade into
the lower table and check for any contact with the metal base or the mitre
table. 3) To avoid injury from an accidental start, make sure the switch is in
the OFF position and the plug is not connected to the power source outlet.
4) Never cut metals or masonry products with this tool. This mitre saw is
designed for use on wood and wood-like products only.
8.12 Bevel stop adjustment (Fig. 14, 15, 16)
WARNING! To avoid injury from an accidental start, make sure the switch is
in the OFF position and the plug is not connected to the power source
outlet.
8.12.1 90° (0°) Bevel adjustment (Fig. 14)
 Loosen bevel lock handle (1) and tilt the cutting arm completely to the right. Tighten the
bevel lock handle.
 Place a combination square (2) on the mitre table with the ruler against the table and the
heel of the square against the saw blade.
 If the blade is not 90° square with the mitre table (5), loosen the bevel lock handle (1), tilt
the cutting head to the left, loosen the locknut (4) and turn the bevel angle adjustment bolt
(3) in or out with a 10 mm wrench until the blade is square with the table.
 Tilt the cutting arm back to the right at 90° (0°) bevel and recheck for alignment.
 Repeat steps 1 through 4 if further adjustment is needed.
 Tighten bevel lock handle and locknut (4) when alignment is achieved.
8.12.2 90° Bevel pointer adjustment (Fig. 15)
 When the blade is exactly 90° to the table, loosen the bevel indicator screw (1) using a
Phillips screwdriver.
 Adjust bevel indicator (2) to the “0” mark on the bevel scale and retighten the screw.
WARNING: To avoid injury from an accidental start, make sure the switch is
in the OFF position and the plug is not connected to the power source
outlet.