Powerplus POWX075 TELESCOPIC MITRE SAW 2000W 305MM EN - Manual (Page 8)

POWX075
EN
Copyright © 2014 VARO P a g e | 8 www.varo.com
8.9 Mounting and adjusting the table extenders (fig. F)
Using the table extenders you can support long workpieces. The table extenders can be
mounted both to the left and to the right of the machine.
 Insert on each side a table extender (33) into the openings in the base of the machine as
shown in the illustration.
 Secure each extender by tightening the lock knob (34).
8.10 Mounting and adjusting the vice (fig. G)
The vice can be mounted both on the left-hand and on the right-hand side of the machine.
 Loosen the lock knob (35).
 Place the vice (36) into one of the mounting holes in the base of the machine as shown in
the illustration.
 Tighten the lock knob.
 Unscrew the vice far enough to place the workpiece.
 Fasten the vice so the workpiece is clamped tightly between the vice and the table top (13).
8.11 Instructions for use
 Slide the head of the machine as far backward as possible and fix the head in this position.
 Pull out the head lock down knob (5) to raise the head of the machine.
 Keep the workpiece pressed to the table and the guide fence.
 Make sure that the saw blade has reached full speed before it touches the workpiece.
 Depress the head with equal force to allow the saw blade to cut through the workpiece and
enter the table slot.
 Do not exert pressure on the saw blade. Allow the machine enough time to cut the
workpiece.
 Only raise the head after the saw blade has come to a complete standstill.
9 OPERATION
9.1 Switching on and off (fig. A)
 To switch the tool on, keep the lock-off button (2) depressed and press the on/off switch
(1)
 To switch the tool off, release the on/off switch (1).
Your POW X075 has a soft start function. Always allow the saw to reach full speed before you
start cutting.
9.2 Sliding cut (fig. A&H)
Using the slide mechanism the cutting capacity can temporarily be enhanced for cutting off wide
workpieces.
 Lock the head of the machine in its lowest position.
 Loosen the lock knob (6) and slide the head to the front.
 Clamp the workpiece in the vice (36).
 Follow the "Instructions for use", but keep the machine switched on.
 As soon as the head has been fully depressed, push it with equal force to the rear to allow the
saw blade to further cut through the workpiece.
 Only raise the head after the saw blade has come to a complete standstill.
9.3 Grooving (tig. I)
 Make sure that the groove stop (8) is in position.
 Perform a sliding cut as described above to make a groove.
 Cancel the grooving feature after use.