beautypg.com

Additional safety instructions for lasers, Assembly, Mounting the machine (fig. a) – Powerplus POWX075 TELESCOPIC MITRE SAW 2000W 305MM EN User Manual

Page 6: Adjusting the sawing angle (fig. a&b), Adjusting the bevel angle (fig. a&c)

background image

POWX075

EN

Copyright © 2014 VARO

P a g e

| 6

www.varo.com

 Do not use saw blades made of HSS steel.
 Do not use bent, deformed or otherwise damaged saw blades.
 Do not use saw blades which do not meet the specifications stated in this manual.
 Before sawing, remove all nails and other metal objects from the workpiece.
 Never start sawing before the saw reaches its full speed.
 Securely clamp the workpiece.
 Never attempt to saw extremely small workpieces.
 Only leave the machine after switching off and when the saw blade has come to a

complete standstill. Pull down the saw head and press in the locking knob.

 Never try to slow the saw blade down by exerting pressure on the side.
 Before performing maintenance to the machine, always unplug the machine.

7 ADDITIONAL SAFETY INSTRUCTIONS FOR LASERS

Warning! The laser beam potentially causes severe eye damage. Never look
or stare directly into the laser beam.

During use, do not point the laser beam at people, directly or indirectly
through reflecting surfaces.

 This laser complies with class 2 according to EN 60825-1:1994. The unit includes no

servicing components. Do not open the housing for any reason. If the unit is damaged,
have the damage repaired by an authorized repair agent

8 ASSEMBLY

8.1

Mounting the machine (fig. A)

The machine must be screwed to a workbench.
 Mark the position of the mounting holes (9) on the workbench.
 Drill holes at each of the marked positions, adjusting the diameter and depth of the holes

to the screws used.

 Place the machine on the workbench and insert the screws into the mounting holes.
 Firmly tighten the screws.

8.2

Adjusting the sawing angle (fig. A&B)

 The default angle between the saw blade and the saw table is 90°.
 Use a set square to check that the angle between the saw blade and the table top (13) is

90°. If the angle does not measure 90° adjust as follows:

 Loosen the head lock down knob (5) and move the head so the saw blade reaches a 90°

angle.

 Loosen the locknut on the adjusting screw (18) and screw the adjusting screw in or out to

achieve a 90° angle. Retighten the locknut.

 Tighten the lock knob.
 Loosen the screw (19) and adjust the pointer (20) so that it registers 0°. Tighten the screw.

8.3

Adjusting the bevel angle (fig. A&C)

 The max. bevel angle is 45°.
 Loosen the lock knob (16) and turn the head to the utter bevel angle.
 Check the bevel angle using the scale (15). If the angle does not measure 45° adjust as

follows:

 Loosen the locknut on the adjusting screw (21) and screw the adjusting screw in or out to

achieve a 45° angle. Retighten the locknut.