Powerplus POWX075 TELESCOPIC MITRE SAW 2000W 305MM EN - Manual (Page 7)

POWX075
EN
Copyright © 2014 VARO P a g e | 7 www.varo.com
8.4 Checking and adjusting the saw blade depth (fig. C)
 Follow the "Instructions for use" to perform a test cut.
 If the saw blade does not cut the workpiece completely,adjust as follows:
 Loosen the lock nut (22) on the adjusting screw (23).
 Turn the adjusting screw to allow the saw blade to achieve the required depth.
 Tighten the lock nut.
8.5 Replacing the saw blade (fig. D)
Before replacing the saw blade always unplug the tool. Do not use saw blades
made of HSS steel. Only use saw blades suitable for a speed of at least 6000
min
1
. Make sure that the spindle diameter and the saw blade bore match.
Only use sharp and undamaged saw blades. Cracked or bent saw blades must be replaced
immediately.
 Lock the slide mechanism.
 Lock the head of the machine in its highest position.
 Keep the unlock handle machine head (3) depressed and turn the lower saw blade guard
(12) fully upward. Place the supplied wrench onto the fixing screw (24).
 Depress the lock knob (25) and keep it depressed.
 Loosen the fixing screw (24) and remove it.
 Remove the outer flange (26), the old saw blade (27), the adapter (28) and the inner
flange (29).
 Clean the flanges and the adapter.
 Place the inner flange and the adapter.
 Place the new saw blade with the teeth pointing in the direction of rotation. See the arrow
on the housing (30).
 Place the outer flange on the saw blade.
 Mount the fixing screw and tighten it.
 Lower the saw blade guard.
8.6 Setting the mitre angle (tig. A)
The mitre angle is left/right infinitely variable between 0° and 45°.
 Loosen the lock knob (7).
 Set the required mitre angle using the scale (10).
 Tighten the lock knob.
8.7 Setting the bevel angle (fig. A)
The bevel angle is infinitely variable between 0° and 45°.
 Loosen the lock knob (16).
 Set the required bevel angle using the scale (15).
 Tighten the lock knob.
8.8 Setting the groove depth (fig. E)
Using the grooving feature, the machine can be used to make crosswise or slant grooves in
workpieces.
 Slide the groove stop (8) into position.
 Loosen the lock nut (31) on the adjusting screw (32).
 Turn the screw in or out to set the groove depth.
 Tighten the lock nut.
 Slide the groove stop out of the way to cancel the groovingfeature.