Powerplus POW8002 MITRE SAW 1400W 210MM EN - Manual (Page 9)

POW8002
EN
Copyright © 2014 VARO P a g e | 9 www.varo.com
8.2 Fitting the work piece support
Work-piece support retaining holes
Locate the retaining rods into the retaining holes.
Note: The retaining rod can be fitted to either or both sides of the saw de-
pending on which type of cut and work-piece is being used.
9 CLEANING AND MAINTENANCE
note: always ensure that the saw is turned off and the plug is removed from
the mains supply before any repairs or maintenance are carried out.
9.1 Cleaning
 After each use brush off any wood chippings with a soft brush. Pay special attention to the
inside of the dust extraction port (where the dust bag fits to the saw) as this is where there
will be a large build up if left for extended periods.
 The motor of the saw should be cleared of any wood chippings as there would be a risk of
fire if they are allowed to build up over time (a soft brush or dry air could be used to clear
the motor).
 Empty the bag after each use; there is a zip on the bag to allow for easy disposal of wood
chippings.
 Ensure the blade guard is kept clean with a damp cloth (do not clean the guard or any part
of the saw with a corrosive solvent) to reduce the risk of injury.
 Periodically oil all the moving parts on the saw to extend the life of the saw.
9.2 Maintenance
Our machines have been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper machine care and
regular cleaning.