Powerplus POW8002 MITRE SAW 1400W 210MM EN - Manual (Page 7)

POW8002
EN
Copyright © 2014 VARO P a g e | 7 www.varo.com
6.4 Blade replacement
Note: Before replace the saw blade, turn off the switch and disconnect
the plug from the power outlet.
Fig. 3
 Press the spindle lock lever (19) to activate it,
turn the saw blade by hand until it locked.
 Loosen the blade lock bolt by turning it
clockwise using the spanner (supplied).
 Remove the lock bolt, outer flange, saw blade
and inner flange .
 Remove the chips or sawdust from around the
spindle and flanges.
 Fit the new blade, flanges and lock bolt. Check
that the blade rotation direction complies with
that of the motor,
6.5 Fitting the dust bag
Fig. 4
Fit the dust bag (17) onto the dust outlet (23).
7 ADJUSTMENTS
note: always ensure that the saw is turned off and the plug is removed from
the mains supply before any repairs or maintenance are carried out.
7.1 Setting bevel angle
Fig 5
Loosen the lock knob for bevel angle (22) and tip
the saw upper arm left until the pointer point at the
desired angle on the bevel gauge (21), tighten the
lock knob (22).
7.2 Setting mitre angle
Fig 6
Loosen the lock knob for mitre angle (14) and turn
the saw table tip to left or right until the pointer point
at the desired angle on the angle gauge for mitre
angle (7), tighten the lock knob (14).