Powerplus POW8002 MITRE SAW 1400W 210MM EN - Manual (Page 6)

POW8002
EN
Copyright © 2014 VARO P a g e | 6 www.varo.com
 For your safety; remove the chippings and work debris etc. from the table top and from
inside the extraction port before each operation.
 Avoid cutting nails; Remove all nails from the work-piece before cut ting.
 Make sure the shaft lock is released before switching on the saw.
 Be sure that the blade does not come into contact with the base when the blade is in the
lowest position.
 Hold the handle firmly.
 Do not perform any operation freehand. The work-piece must be se cured firmly against
the base and guide fence with the vice during all operations; Using your hand may cause
severe injury.
 Keep hands out of path of saw blade, never reach around saw blade.
 Make sure the blade is clear of the work-piece before the switch is turned on.
 Before making the first cut using the saw, let it run for a while; Watch for vibration or
wobbling that could indicate poor installation or a poorly balanced blade. Adjust or replace
as necessary.
 Allow the blade to run up to full speed before cutting.
 Stop operation immediately if you notice anything abnormal.
 Do not attempt to lock the trigger in the on position.
 Wait for saw blade to stop completely and remove from mains supply before servicing or
adjusting tool.
 Be alert at all times, especially during repetitive, monotonous operations. Don't be lulled
into a false sense of security. Blades are extremely unforgiving.
 Use of improper accessories such as abrasive wheels may cause damage to the saw and
surrounding area as well as increasing the risk of in jury.
 Turn off the saw and wait for it to complete stop before moving workpiece or changing
settings.
 Do not modify the saw to do tasks other than those intended.
6 ASSEMBLY
Note: always ensure that the saw is turned off and the plug is removed from
the mains supply before any repairs or maintenance are carried out
6.1 Bench mounting
The saw base has mounting holes (10) in each corner to facilitate bench mounting .
Mount the saw to a level bench or work table by using bolts (not supplied) and rubber foot
(supplied).
6.2 Release knob
The release knob (18) is provided for holding the cutting head down while transporting or
storing the mitre saw, The saw must never be used with the release knob locking the head
down.
6.3 Spindle lock lever
The spindle lock lever (19) prevents the blade in the saw from rotating. Depress and hold the
spindle lock lever while using spanner to install or remove the blade.