Casio SE-S3000 Manual - Manual (Page 91)

E-91
Use
ful
fe
atu
re
s
Advanced programmings and registrations
Programming further clerk functions
This section explains how you can set further programming for clerks such as
setting the register in training mode or setting commission rates given to clerks. In
the training mode, the register operates normally but the results will not be stored
in the memory. You can use this feature for getting to know the operations of the
cash register for yourself or for newly hired clerks.
Step
Operation
1
Turn the Mode switch to PGM position and select [System
Setting] then press F key.
> ▪▪▪▪▪ >F
2
Enter 3 and press o key to set the register in the
programming mode.
3o
3
Enter 2 -digit clerk number followed by 07. The “07” is the
identification code for further program of clerks. Then press
o key. The example on the right is for programming to clerk
number 10.
1007o
(Clerk no.)
4
Referring the following tables, input the set code you wish
to program and press o key. The example on the right
is for setting a commission rate.
68o
(set code)
5
Enter the program code and press F key. The ex-
ample on the right is for setting 8.5% to commission rate 1
and 5% to commission 2.
08500500F
(program code)
6
If you wish to set the same program to the next clerk
number, perform the step 5 again. when you set to another
clerk (not next clerk number), repeat steps 3 through 5.
7
Press o key to complete the settings. o
Set code 67 (Training mode)
Description Selection Program code
Training mode No = 0
Yes = 1
B
D6
Must be “00000” ººººº
D5 D4 D3 D2 D1
Example 1: To set the clerk number 15 as a clerk being trained.
Press 3o1507o100000Fo
Set code 68 (Commission rates)
Description Selection Program code
Commission rate 1 (integer)
00 to 99
BB
D8 D7
Commission rate 1 (decimal)
00 to 99
BB
D6 D5
Commission rate 2 (integer)
00 to 99
BB
D4 D3
Commission rate 2 (decimal)
00 to 99
BB
D2 D1