EFJohnson 3000 SERIES User Manual
Page 50

SYSTEM RACK
4-24
2. All PTMs should be installed and configured as
follows:
Switch
Sections Closed
Sections Open
S5, S7
3,4,5,6,7
1,2
S6, S8
2,3,6
1,4,5,7,8
3. Select one of the 8 Backplane boards for measuring.
Measurements can be made on any of the
64-pin connectors on the Backplane selected.
4. All measurements should be referenced to ground
(pins 9, 10, 41 or 42) unless otherwise noted.
5. All test readings should be within 5% of the
following specifications:
Pins
Ohms
16/48
37.5
17/49
37.5
18/50
37.5
19/51
75.0
20/52
37.5
21/53
37.5
22/54
100 (measured to +5V DC*)
23/55
37.5
24/56
100 (measured to +5V DC*)
* Pins 11, 12, 43 or 44.
6. On the top Backplane board, the following measure-
ments should be referenced to ground (pins 9, 10, 41
or 42).
Center Pin of
Ohms
J5
37.5
J6
37.5
J23
19.2
J24
19.2
NOTE: The four readings should be ±1 ohm from
the test specifications.
7. Test is completed.
Disconnect the cables from the Call Processor.