Casio XW-DJ1 Tutorial - Manual (Page 12)

EN-10
djay LE
To output djay LE playback audio from
TRACKFORMER, you need to configure audio device
settings with djay LE. The procedure you use to start
up or shut down TRACKFORMER and/or djay LE
startup can cause settings to change (see the note
below), so be sure to check settings after starting up
djay LE.
NOTE
• Recommended startup: Turn on TRACKFORMER
→
Start up djay LE.
Recommended shutdown: Exit djay LE.
→
Turn off
TRACKFORMER.
1.
On the displayed menu bar, select [djay LE]
and then [Preferences].
2.
Select [Device] and then configure audio
device output settings.
z Master Out: Casio XW-DJ1 Audio out : ch1-2
z Monitor Out: Casio XW-DJ1 Audio out: ch3-4
NOTE
• Note that the initial ch1-2 and ch3-4 settings
immediately after installation may be opposite of
those shown above.
IMPORTANT!
• djay LE is an app designed for use while hardware is
connected. Stand-alone operation on the MAC OS is
not supported.
djay LE does not support the TRACKFORMER’s
Automix or recording functions.
To enable support of all TRACKFORMER functions,
you need to purchase an upgrade to djay Pro. You
can purchase djay Pro by going to the website at the
URL below.
http://www.algoriddim.com/djay-mac
Configuring Audio Device
Settings Precautions when Connecting
to a Computer
If your computer does not recognize TRACKFORMER...
• Check if your computer meets the djay LE
system requirements.
• Try connecting to a different USB port on your
computer.
• Make sure you are using a High Speed
compatible (USB 2.0) USB cable.
• Connect directly to a computer USB port,
without going through a USB hub.
• Shutdown or exit all Wi-Fi, Bluetooth, or other
applications, and anti-virus software.
• Try shutting down camera, and/or game
controller drivers running on your computer.
• You can check the
TRACKFORMER audio and
MIDI connection using the MAC
OS Audio MIDI Setup.
(Finder - Applications - Utilities)
z Check the Audio Window to make sure that XW-
DJ1 is shown.
On the Window menu, select Show MIDI Window
to display the Audio Window.
z Check the MIDI Window to make sure that XW-
DJ1 is shown.
z The MIDI Window will show icons of MIDI
devices that have been used in the past. Delete
the icons of MIDI devices that you no longer
need to use. You can delete an icon by selecting it
and then pressing your computer’s DELETE key.