Casio DT-X7 - Manual (Page 49)

E-47
4. Connect the USB cable (DT-380USB) to the USB client port on the back of the USB
Cradle, and then connect it to the PC. The USB host port is used when connecting the
cradle with other USB peripheral device.
USB peripheral device
PC
5. Align the contacts on the bottom of the DT-X7 with the power contacts of the
USB Cradle when inserting the unit.
The power LED on the front of the USB Cradle will light green if the Handheld
Terminal has been properly mounted.
Status of Indicator 1 on DT-X7:
Orange: Charging the battery pack.
Red:
Standby due to battery pack error or the surrounding temperature is out of the
charging temperature range.
(charging begins when the temperature is within the charging temperature range)
Green: Charging the battery pack is complete.
Important!
Always make sure to fi rst remove the Handheld Terminal from the USB Cradle
when switching the selector switch.
Allowing the power contacts become wet can cause an electric shock or fi re. In
addition, if the contacts become soiled, contact may be impaired resulting in
poor charging. For reasons of safety and maintaining charging battery pack(s)
in optimum condition, clean the power contacts by wiping with a dry cloth or
cotton swab after disconnecting the AC adaptor.
Never short out the power contacts of the USB Cradle. This can damage the
USB Cradle. •
•
•