Epson P-3000 - Manual (Page 3)

Epson P-3000/P-5000
9/06 Epson P-3000/P-5000 - 3
Installing/Replacing the Battery
Follow these steps to install or replace the Lithium ion battery:
1. Turn the viewer upside down and slide the battery cover to
the right to open it.
2. If you need to remove the battery, follow the instructions
below, then return here to step 3.
3. Insert the battery into the compartment in the direction of
the arrow on the battery.
4. Close the battery cover and slide it to the left until it clicks.
Removing the Battery
If you need to replace the battery or plan to store the viewer
for an extended period of time, follow these steps to remove
the battery:
1. Make sure the viewer is turned off.
2. Remove the AC adapter if it is connected to the viewer.
Caution:
Never remove the battery while the viewer is turned on. Doing so
may cause files to be lost or damaged.
3. Open the battery cover.
4. Push the latch down. The battery pops out.
5. Pull out the battery. Then close the battery cover.
Charging the Battery
After installing the battery, you need to charge it using the AC
adapter. It takes about 3.5 hours to fully charge the battery
when the viewer is off, and longer when the viewer is on.
The Charge light is green while the battery is being charged.
When the battery is fully charged, the light turns off.
To charge the battery, connect the AC adapter as shown
below. Connect the other end to the power cord, and plug it
into an electrical outlet.
Caution: Do not connect the AC adapter when the battery is not
installed; this can damage the viewer.
The battery status is displayed in the top right corner of the
LCD screen when the viewer is on.
BATT .
BATT . BATT .
: Battery is fully charged.
: Battery power is about half full.
: Battery power is low.
: Battery power is running out. The viewer will shut down
automatically. Charge the battery using the AC adapter.
: Battery is charging.