Eclipse - Fujitsu Ten CD4000 - Manual (Page 56)

56
About optional equipment
Others
Connecting portable audio
players to the AUX jack
Use a commonly available accessory cord. With
the RCA connector to connect a portable audio
players and other external inputs can be
connected to the system.
There are 2 connection terminals on this
equipment; one for RCA connector and the other
for optional LAN cable (AUX 105).
Activation of the AUX mode will light
the "AUX" indicator and channel
audio player output to the system
speakers.
Each time the button is pressed, the
mode will switch as follows:
AUX1(Input)
↔ AUX1(Sub Input)
ATTENTION
• While the AUX mode is activated, actions such
as turning off the audio player or pulling out the
connection cord may cause noise spikes that
can damage the system speakers. Be sure to
avoid this possibility by turning off system
power or switching from the AUX mode to
another mode before shutting off or
disconnecting the portable audio player.
• Audio output levels will differ for the various
devices that can be connected by this method.
Carefully adjust volume until the output level of
the connected player is known.
• Before using a portable audio player in a
vehicle, read the player's operation manual
carefully and confirm problem-free operation in
the vehicle before proceeding.
Changing auxiliary input sensitivity
The sensitivity of the auxiliary mode can be
changed.
The function mode is activated.
The AUX sensitivity mode is
activated.
Turning the button allows you to
toggle through sensitivity modes as
follows:
Low ➔ Mid ➔ Hi ➔ Lowwww
ATTENTION
Input sensitivity modes are roughly as follows:
Low 1 Vrms
Mid 480 mVrms
Hi 240 mVrms
The selected settings will take effect.
At this time, other adjustments can
also be mode in function mode.
1
Turn on the portable audio player
and start its play function.
2
Switch to AUX mode by pressing
the [DISC] button for more than
one second.
3
Press the button [3] to switch the
AUX mode.
1
Press the [ILUM / FUNC] button for
more than one second.
2
Turn the [SEL] button to select
AUX Sensitivity.
3 Press the [SEL] button.
4
Turn the [SEL] button to select the
sensitivity mode.
5 Press the [SEL] button.
6 Press the [RTN] button.
7
Press the [ILUM / FUNC] or [RTN]
button to exit function mode.