Eclipse - Fujitsu Ten CD4000 - Manual (Page 37)

How to operate the AUDIO CONTROL
37
IX
Setting examples:
The volume for the initial FM mode (default value: 40) is used as a reference for storing the differences
in volume that have been set for each audio mode.
*:The volume levels can be set to a maximum of 80 and a minimum of 0. If you try to go past the
maximum or minimum volume level, the level will not change. For the CD changer, SVC
adjusts the volume using the setting value for the CD player.
The volume difference can be set within a range of -10 to +20.
ATTENTION
If the battery terminals have been disconnected because of vehicle maintenance, the SVC settings
will return to their default values. If this happens, you will need to make the settings again.
Mode Function
[AUDIO CONTROL] button
Turn to the Left Turn to the Right
SVC (Source Volume
Control)
Adjusts different volume levels for each
audio mode. When SVC is set, the
volume level can change as shown in the
example settings in the table on the next
page.
Decreases the SVC
setting level. Increases the SVC
setting level.
LOUD
The loudness control may be turned on to
emphasize low and high frequencies at
low volume levels.
Loudness compensates for the apparent
weakness of low and high frequencies at
low volume by boosting the bass and
treble levels.
Turn the loudness control ON/OFF.
Audio mode FM AM CD
Default value
(Volume level)
Reference
(40)
0
(40)
0
(40)
SVC setting
(Volume level)
Reference
(40)
SVC setting
value
+15 (55)
SVC setting
value
-10 (30)
When volume level in FM
mode is adjusted from 40
to 45
45 55 ➔ 60 30 ➔ 35
When volume level in CD
mode is adjusted from 35
to 60
45 ➔ 70 60 ➔ 80* 60
When volume level in AM
mode is adjusted from 80
to 20
70 ➔ 5 20 60 ➔ 0*