Eclipse - Fujitsu Ten CD4000 - Manual (Page 19)

How to operate the CD (MP3/WMA) player
19
IV
Listening to CD (MP3/WMA file)
The front panel opens.
If a disc has already been loaded, the
disc is ejected by pressing the [CD
]
button.
The CD will immediately start playing.
ATTENTION
When a CD is already loaded, press the
[DISC] button to switch to the CD mode.
Switching to the CD player
mode
First press the [DISC] button for less than one
second to switch to the disc mode. It is assumed
here that a CD has already been loaded into the
unit.
This starts CD play.
If an external CD changer and an
optional iPod interface adaptor (iPC-
106) are connected, each additional
press of the [DISC] button will switch
modes from CD player
➔ CD changer
1 ➔ CD changer 2 ➔ iPod ➔ CD
player.
A changer or player with no discs
loaded will be skipped.
ATTENTION
• Playback may be intermittent when there is
a scratch on a CD or when the recorded
side is dirty.
• Only two external CD changers may be
connected.
1 Press the [CD ] button.
2
Insert a CD into the disc slot, label
side up.
● Note ●
• When music data recorded in
the normal way (CD-DA) is
present on the same disc with
MP3/WMA music files, the
normally recorded music data
will be played. To listen to the
MP3/WMA music files, press
the button [3] for more than one
second.
• When a non-MP3/WMA file is
played, "NO SUPPORT" will
appear.
• The optional CD changer
cannot be used to play MP3/
WMA files.
CAUTION
Do not press the [ CD ] button while CD is
being inserted. This could cause an injury
and damage to the front panel.
1
Press the [DISC] button for less
than one second to switch to the
CD player mode.