Eclipse - Fujitsu Ten CD4000 - Manual (Page 31)

ESN security operating procedure
31
VII
What happens if an incorrect CD is
inserted?
After the [HELP] message appears for five
seconds, serial number will appear.
After the [SEC] message appears for two
seconds, rolling code (six digit) will appear.
[DISC] flashes on the display.
You will have five more attempts to
insert correct disc.
If the correct CD is inserted, an [OK]
message will appear for two seconds
and the CD will be ejected.
ATTENTION
• If an incorrect CD is inserted, an [ERR_ ]
("ERR" and error number) message will
appear for two seconds, after which the CD
will be ejected.
• This process cancels the protection for ESN
equipment.
How to turn the security
indicator on/off
Once ESN security is activated, the indicator
flashes whenever the vehicle's ignition switch is
turned off, warning potential thieves that the
equipment is protected. However, if do not want
this visible deterrent, it may be turned off.
[IND. FLASH] means the security
indicator will flash when the vehicle's
ignition switch is off, and [IND.-----]
means it will not. Repeat the above
steps to reactivate the flash mode.
How to read the Electronic
Serial Number
[ESN] appears on the display, followed
by an eight-digit number; this number
is your electronic serial number (ESN).
You may use this number to identify
your Eclipse CD4000 in the event of
theft recovery.
1
After the 5th incorrect attempt, the
display reads [HELP] for five
seconds.
2 Press the [CD ] button to close
the front panel.
3
Press the [ILUM / FUNC] button,
then the button [6], and hold them
for five seconds.
4
Press the [ILUM / FUNC] button.
5 Insert the Key CD into the slot.
● Note ●
If after 5 tries the correct Key CD is not
inserted, the display will read [CALL];
the equipment must be returned to
Eclipse to be reset. In this case,
please contact your Eclipse dealer for
assistance.
Your Key CD can be easily forgotten.
Write the album name in a reminder
note (See page 63).
1
With the equipment in standby,
press the [ILUM / FUNC] button,
then the button [2] and hold both
for more than one second.
2
[IND. FLASH] or [IND.-----] appears
on the display.
1
Check that the equipment is in
standby.
2
Press and hold the [ILUM / FUNC]
button, then button [4], and hold
both for more than one second.