Curtis TID5030 - Manual (Page 8)

1. Pick up the handset.
2. Press the [AUTO] key, and then press the digital key (1-0) where the number was
stored.
3. The number is dialed automatically.
Note: there is a time-out for storing numbers. If the unit times out before the number
is stored, try again.
CALLER ID
When you are subscribed to caller ID service and a call is received, the unit will
display the caller information sent by the telephone company .including: telephone
number (if available), and the date and the time of the call. Calls are put in sequence
and numbered to indicate their place in the sequence.
When more than 80 calls have been received, the oldest messages are replaced with
the new call information.
When you receive more than one call from the same telephone number, the display
will show REP in the upper right corner to indicate it is a repeat call. Only the most
recent repeat call is recorded, and REP indication goes away after the record has been
viewed.
TO DELETE CALL(S) FROM MEMORY
For Incoming Call(s):
1. Press [
], [ ] to select the phone number(s).
2. Press the (DELETE) button twice within 2 seconds to delete.
For Outgoing Call(s):
1. Press (OUT) & the (DELETE) buttons twice within 2 seconds to delete.
2. ALL the phone number(s) stored in the memory will be delete(d).
Note:
In on-hook mode, Press to delete the pre-dialed numbers one-by-one.
In off-hook mode, Press to start calling timer.