Curtis TID5030 - Manual (Page 4)

Wall mounting the telephone.
The unit may be wall mounted either on a telephone wall plate or with two screws (not included).
If using screws, insert them into the wall leaving 3/16’’ of each screw extending out from the wall.
When installing screws into plasterboard walls, use wall anchors(not included) to ensure that the
screws remain secure.
1. Run the AC power cord down through the provided cable channel for flush wall mounting.
2. Slip the telephone base onto the wall, lining up the wall mounting holes over the screws. Slide
the telephone base down so it is firmly in place.
3. Finish installation by following steps
TELEPHONE OPERATION
SET KEY
SETTING (for area number/local number/time/date/alarm setting)
While continuously holding down the hook switch or when the telephone line
cord is disconnected.
Press key to enter the setting mode
z One time- To enter area number
z Two times- To enter local number setting
z Three times- To enter data/time setting (only selectable for 12 hour format with