Curtis TID5030 - Manual (Page 5)

AM & PM indicator).
z Four times- To enter volume setting.(Note: This function is invalid in this unit )
z Five times- To enter ring tone setting(Note: This function is invalid in this unit)
z Six times - To enter flash time setting(600mS/300mS/100mS/80mS)
z Seven times- To enter pause time setting
z Eight times - To enter clock alarm1 setting (Note: this function is invalid in this
unit)
z Nine times- To enter clock alarm 2 setting (Note: this function is invalid in this
unit)
z Ten times – To enter clock alarm 3 setting (Note: this function is invalid in this
unit)
To exit the setting mode, press key.
Note: it will automatically go back to normal mode if there is no key pressed within
24 seconds.
During the settings, press
Review Left Up[ ] Key - to change content
Review Right Down[ ] Key - to change site
Key to adjust
Press or key to enter next mode
DATE & TIME SETTING
1. Enter into Date & Time setting mode (Press button, three times for
setting the date and time, Press Review Left Up[ ] Key to change content,
Review Right Down[ ] Key - to change site)
2. Enter your desired date by directly pressing the Digital key (0-9) directly for setting the
date. (For example: Dec, 25 th , press “1” “2” for the month, and “2” “5” for
the date/ for Feb, 2 nd , press “2” for the month and “2” for the date.)
3. Enter your desired time by directly pressing the Digital key (0 -9) directly
(only 12 hours format/ Setting range: Hour: 00- 12; Minute: 00-59)
For example: 3:25pm, press “1” “5” for hour, and “2” “5” for minute. And
the “pm” will show on the display as “pm 3:25”, For 4:00am, press “4” for
the hour, and “0” “0” for the minute. And the “am” will show on the display
as “am 4:00”