Curtis TID5030 - Manual (Page 11)

ALARM OFF
Slide the AUTO/OFF/ON switch to “OFF” position if you wish to turn off the radio or buzzer after
the radio or buzzer has sounded in the Wake to Radio or Wake to Buzzer operation. The alarm will
not sound again until the next day unless you switch back to “AUTO” position or use alarm button
to shut off alarm, then the radio or buzzer will automatically sound again in 24 hours at the same
alarm setting.
SLEEP CONTROL
Step 1 --- Turn the AUTO/OFF/ON switch on the “AUTO” or “OFF” position.
Step 2--- Press the SLEEP button to display the sleep time. The display will indicate 59 minutes. If
you wish the radio to play for a shorter period simply press the SLEEP button together with the
MINUTE button to set the desired time period, or if you wish to play longer, press SLEEP button
along with HOUR button top play for 1 hour and 59 minutes (MAX).
Step 3 --- Press the SLEEP button. The radio will turn on automatically and will turn itself off
when the pre-set time has passed.
NOTE: The maximum sleep time is 1 hour and 59 minutes.
The radio will be switched off automatically when the sleep time expires. To turn the radio off
before expiration of sleeping time, simply press the “SNOOZE BUTTON”.
Cleaning and maintenance:
1. Keep the phone away from bathtub, water or very high heat and humidity (Keep
away from stove or radiators).
2. Avoid placing it in very hot sun.
3. Don’t staple phone cord
4. Do not, under any circumstances, disconnect the cord from the telephone without
disconnecting the cord from the telephone line first. Ringer voltage can be high
and dangerous.
5. Cleaning the exterior surface of the set should be done on a regular basis. Use a
cloth slightly dampened with warm, clean water to remove excess dust and dirt.
6. Do Not use waxes, solvents or detergents of any kind to clean your set.
These products can damage the surface of the set. Use only a cloth slightly
dampened wither water and if necessary a little dishwashing liquid. Do not allow any
liquids to get inside the set.
7. Electronic products should never be subjected to extreme temperatures or high