Enterasys Networks 9033348-02 - Manual (Page 39)

Antenna Installation 3-5
Lightning Protector Installation
To install the RoamAbout Lightning Protector, perform the following steps:
1. Determine a suitable location for the Lightning Protector as described in Chapter 2 .
2. As shown in Figure 3-2 , secure bracket (A) to the wall using two screws (F).
3. Use a ring-terminal to connect ground-wire (C) to bolt (B). The ring-terminal and
ground wire are provided by the installer.
4. Secure bolt (B) to the bracket using washers and locknut (D).
5. Loosely install washers and hexnut (G) onto the RoamAbout Lightning Protector (E).
6. Insert the Lightning Protector into the opening in bracket (A).
7. Tighten hexnut (G) to secure the RoamAbout Lightning Protector in its position, and
ensure that the Protector is properly connected to the grounding system.
To avoid damage to the RoamAbout equipment, always install the RoamAbout
Lightning Protector between the outdoor antenna installation and the RoamAbout
Access Point or other computing device connected to the outdoor antenna.
Figure 3-2: Lightning Protector Installation
A
B
F
C
D
G
E