Eaton Electrical Powerware 5130 Rack/Tower UPS 1250-3000 VA - Manual (Page 64)

TROUBLESHOOTING
EATON Powerware ® 5130 Rack/Tower UPS (1250–3000 VA) User’s Guide S 164201730 Rev 2
www.powerware.com
58
Table 17. Troubleshooting Guide
Alarm or Condition Possible Cause Action
When starting the UPS with the
button, all the indicators turn on
once, the alarm beeps once, and
then
indicator remains on.
The remote power-off (RPO)
contact has been activated to
shut down the UPS and now
prevents restart. Set the contact back to its normal position
and press the
button to restart.
The button, and
indicators are on and all the
bar graph indicators flash.
μ The percent load is greater than
the set overload level or UPS
capacity. Check the power drawn by the connected
devices and disconnect any non-priority
devices. Check the overload setting.
The button and indicator
are on and all the bar graph
indicators flash.
A critical overload has occurred.
If utility power fails, the load will
not be protected in Battery
mode. Check the power drawn by the connected
devices and disconnect any non-priority
devices.
The indicator is on and all the
bar graph indicators flash.
A battery fault has been
detected during the automatic
test. Replace the battery (see “Replacing
Batteries” on page 46).
The indicator alone is on and
the alarm sounds continuously.
UPS fault condition. The load is
not supplied. Contact your service representative.