Epson POWERLITE 5010E - Manual (Page 69)

Problem Solving
69
Power light flashes
blue, power button
is on The projector is warming up. Wait for the picture to appear.
The projector is cooling down. Wait until the power light stops
flashing and remains off. Then press the
P power button on the
projector or the On button on the remote control to turn it back
on.
Power light and
power button are
on Projection is in progress.
Lights indicating a problem
Light state Cause and solution
All lights are off The projector is not receiving power. Make sure the power cord is
connected securely at both ends.
The temperature
light flashes
orange High-speed cooling is in progress. If the temperature rises
further, projection will stop automatically. Make sure there is
plenty of space around the projector for ventilation. Clean or
replace the air filter if necessary (see page 61).
If you are using the projector at an altitude above 4921 feet (1500
meters), turn on High Altitude Mode so the fan can cool the
projector properly (see page 52).
The temperature
light is red The projector is too hot, which turns off the lamp automatically.
Let the projector cool for five minutes, then turn it back on. Make
sure there is plenty of space around the projector for ventilation.
Also, clean or replace the filter if necessary (see page 61).
If you are using the projector at an altitude above 4921 feet (1500
meters), turn on High Altitude Mode so the fan can cool the
projector properly (see page 52).
The lamp light
flashes orange The lamp needs to be replaced.
The lamp light
flashes red There is a problem with the lamp. If you just replaced the lamp,
make sure the lamp and its cover are securely installed (see
page 63). Turn off the projector and unplug it from the electrical
outlet. Wait for the lamp to cool, then remove the lamp and check
it for cracks. If the lamp isn’t cracked, reinstall it, plug the
projector into an outlet, and turn the power on. If this doesn’t fix
the problem, or if the lamp is cracked, contact Epson for
assistance (see page 76).
Lights indicating normal operation
Light state Cause and solution