Magnum Energy CSW1012 - Manual (Page 7)

© 2013 Magnum Energy, Inc. 3
2.0 Installation
2.0 Installation
Review this section and the Important Product Safety Instructions before
proceeding with the installation of your inverter.
WARNING: Installations should be performed by qualifi ed per-
sonnel, such as a licensed or certifi ed electrician. The installer
determines which safety codes apply and ensures all applicable
installation requirements are followed. Applicable installation codes
vary depending on the specifi c location and application.
WARNING: Review the “Important Product Safety Information” on
page ii and adhere to all cautionary markings located on the inverter
and on the batteries.
2.1 Pre-Installation
Before proceeding, read the entire Installation section to determine how
best to install your CSW1012 inverter. The more thorough you plan in the
beginning, the better your inverter needs will be met. The simplifi ed system
diagram shown in Figure 2-1 should be reviewed to assist you in planning
and designing your installation. This drawing is not intended to override or
to restrict any national or local electrical codes. This drawing should not be
the determining factor as to whether the installation is compliant, that is the
responsibility of the electrician and the onsite inspector.
2.1.1 Installation Guidelines
• Before connecting any wires, determine the cable routes throughout the
home or vehicle/boat, both to and from the inverter.
• Always check for existing electrical, plumbing, or other areas of poten-
tial damage BEFORE drilling or cutting into walls.
• Make sure all wires have a smooth bend radius and do not become kinked.
• If installing this inverter in a boat, RV or truck, ensure the conductors
passing through walls, bulkheads, or other structural members are pro-
tected. This minimizes insulation damage (such as chafi ng) which can
be caused by vibration or constant rubbing.
2.1.2 Unpacking and Inspection
Carefully remove the inverter from its shipping container and inspect all
contents. Verify the following items are included:
• CSW1012 inverter
• CSW1012 Owner’s Manual
If items appear to be missing or damaged, contact your authorized Magnum
Energy dealer or Magnum Energy.
*** Save your proof-of-purchase as a record of your ownership; it is
needed if the unit should require in-warranty service. ***
2.1.3 Tools Required
Installing the inverter is simple and requires the following:
• Adjustable wrench (10mm)
• Level • Drill
• #10 Mounting screws (x4) • Pencil • Drill bits
• Phillips screwdriver