Logitek Electronic Systems ROC - Manual (Page 17)

Logitek ROC Reference Manual
Page 17
4 Configuration
This chapter covers basic configuration information, relating specifically to the ROC surface.
JetStream
setup and configuration is covered in detail in the following manuals:
 Logitek JetStream Reference Manual
 Logitek AEConfig Reference Manual
JetStream Configuration
Configuration of the JetStream Router is done in JetSet.
 See the JetStream Reference Manual for information on configuring JetStreams
Audio Engine Configuration
Configuration of the Audio Engine is done in AE Config.
Currently, AEConfig does not include specific DSP table entries for the ROC. You should use a
Mosaic surface of the appropriate size when configuring a ROC. In the future, specific ROC support
will be added to AEConfig, however, the two consoles are compatible in DSP allocations. Ignore the
entries for ROC-5 and ROC-10; those are used in the 1990's era ROC console.
 See the Audio Engine Reference Manual for information on configuring Audio
Engines.
CommandBuilder Triggers
The ROC surface contains many programmable buttons and features. These features are scripted in
“triggers” in CommandBuilder, and executed by JetStream Server, which is included with the
JetNet Audio Networking Module.
 See the CommandBuilder User’s Manual for information on writing Triggers.