Logitek Electronic Systems ROC - Manual (Page 28)

Logitek ROC Reference Manual
Page 28
Using the Change Function
When you press Change over a fader, the select portion of the Monitor Module reacts as follows in
the following modes:
Main
The change function always defaults to this mode. Press the Main button to return to this mode
from another mode if desired.
Turn the red Select knob to change the source over a fader. Press Take to confirm.
The monitor module will light up with 3 additonal options in three columns on the meter bridge
under the monitor meter: Trim, pan (balance), and mode. Turn the green knob that corresponds
with the column to adjust each control. Press Take to confirm.
The green LED will light next to each active green knob when there is something that you are
allowed to change. If the trim, pan, and mode controls do not light up, those functions have been
locked out in the JetStream or Audio Engine configuration software.
Comp (Compression/Limiting)
Press the Comp button to enter this mode while change is active. Several pages of compressor
controls are available in this menu displayed under the monitor meter on the meter bridge. Use the
red Select knob to change pages. Turn the green knob that corresponds with the column (left,
center, right) to adjust the settings displayed on the meter bridge. Press the right hand knob to set
compression IN or OUT as desired. If Allow Effects is not set to Yes for the source in the
JetStream/Audio Engine configuration software, this menu will be completely turned off.
EQ (Equilization)
Press the EQ button to enter this mode while change is active. Several pages of EQ controls are
available, and the red Select knob changes the pages displayed under the monitor meter on the
meter bridge. Turn the green knob that matches the column. Press the far right green knob to set
EQ IN or OUT as desired. If Allow Effects is not set to yes for the source, the menu will be
completely turned off.
MISC (Miscellaneous)
Reserved for future use. Currently, pressing this button sends change mode back to Main.