Logitek Electronic Systems ROC - Manual (Page 13)

Logitek ROC Reference Manual
Page 13
ROC-F18 18 Slot Frame
 Houses 3x ROC-FADER & 1x ROC-MON
 25.6” W x 14.3” D x 2.5” H (625mm x 368mm x 63mm)
ROC-24 Frame
 Houses 4x ROC-FADER & 1x ROC-MON
 33.95” W x 15.4” D x 2.6” H (862mm x 391mm x 66mm)
Meter Bridges (ROC-SMeter, ROC-LMeter)
Hardware LED Meter Bridges are available as an option. The Meter includes two high-resolution
meters – one for Program bus and one switched (follows Monitor selection).
 TIP: If the ROC is powered on without being connected to the JetStream, all meter LEDs
will illuminate. This is normal operation; the LEDs will turn off after being
connected to the JetStream and the console begins to receive meter data.
Mounting
 The Meter option is supplied separately and attaches to the back of the ROC frame with
screws (included).
 The RJ-11 cable from the Meter plugs into the ROC tray card at the far right into the jack
labeled “Meter.”
 The Meter is hinged. Gently tighten the black center screw on the rear of the hinge to lock
the meter into place at the desired angle.
Illustration 1: ROC-SMeter