Linx Technologies MDEV-xxx-ES - Manual (Page 2)

Table of Contents
1 Introduction
2 Ordering Information
3 ES Series Transmitter Development Boarad
4 ES Series Receiver Development Boarad
5 Using the Development Boards
5 Troubleshooting
6 The Prototyping Area
7 Using the Simplex Encoder / Decoder Section
7 Using the Data Squelch Circuit
8 Using the Encoder and Decoder
9 Range Testing
10 Host Interface Module
11 Master Development Software
11 About Antennas
12 Using the Boards as a Design Reference
12 In Closing
13 USB Host Interface Board Schematic
13 RS232 Host Interface Board Schematic
13 RF Section Schematic
14 Header Section Schematic
14 Squelch Circuit Schematic
14 Power Supply Section Schematic
15 Encoder/Decoder Section Schematic
Warning: Some customers may want Linx radio frequency (“RF”)
products to control machinery or devices remotely, including machinery
or devices that can cause death, bodily injuries, and/or property
damage if improperly or inadvertently triggered, particularly in industrial
settings or other applications implicating life-safety concerns (“Life and
Property Safety Situations”).
NO OEM LINX REMOTE CONTROL OR FUNCTION MODULE
SHOULD EVER BE USED IN LIFE AND PROPERTY SAFETY
SITUATIONS. No OEM Linx Remote Control or Function Module
should be modified for Life and Property Safety Situations. Such
modification cannot provide sufficient safety and will void the product’s
regulatory certification and warranty.
Customers may use our (non-Function) Modules, Antenna and
Connectors as part of other systems in Life Safety Situations, but
only with necessary and industry appropriate redundancies and
in compliance with applicable safety standards, including without
limitation, ANSI and NFPA standards. It is solely the responsibility
of any Linx customer who uses one or more of these products to
incorporate appropriate redundancies and safety standards for the Life
and Property Safety Situation application.
Do not use this or any Linx product to trigger an action directly
from the data line or RSSI lines without a protocol or encoder/
decoder to validate the data. Without validation, any signal from
another unrelated transmitter in the environment received by the
module could inadvertently trigger the action.
All RF products are susceptible to RF interference that can prevent
communication. RF products without frequency agility or hopping
implemented are more subject to interference. This module does not
have a frequency hopping protocol built in.
Do not use any Linx product over the limits in this data guide.
Excessive voltage or extended operation at the maximum voltage could
cause product failure. Exceeding the reflow temperature profile could
cause product failure which is not immediately evident.
Do not make any physical or electrical modifications to any Linx
product. This will void the warranty and regulatory and UL certifications
and may cause product failure which is not immediately evident.
!