LinPlug SaxLab - Manual (Page 30)

Rear Panel
SaxLab 2’s Rear Panel is accessed by clicking on the SaxLab 2 logo on the
instrument's Front Panel. The Rear Panel contains a control for the path to the
library, an edit box which is used for registering the instrument and a display
that shows the version of the instrument.
Library: The Library Path is located on the upper left of the instrument's Rear
Panel. Usually it points to where the library have been installed, however, if
you want to move the library to a different location you can do this and use
this control to make the new location available to SaxLab. After clicking the
folder icon a file dialog opens and allows you to browse to the library.
Attention: You cannot select the folder directly, you need to locate the library,
then open the “Alto Layers” folder and open the “sax.sxlbsnd” file in it.
After adjusting the path to the library you need to restart SaxLab, that is to
unload it completely and load it again.
Serial Number: The Serial Number edit box is located on the upper left of the
instrument's Rear Panel. The Serial Number edit box is used to register the
instrument. Note that before entering a valid serial number, the Serial Number
edit box reads “Enter here”. After a valid serial number has been entered the
Serial Number edit box reads “Valid”.
Version Number: The Version Number display is located on the upper right of
the instrument's Rear Panel. It shows the version of the instrument.
Clicking on the SaxLab 2 logo in the middle of the Rear Panel returns you to
the Front Panel.
SaxLab 2.1.6 User Manual Page 30