Bang & Olufsen BeoVision 8-40 User Guide (pre Aug 2010) - Manual (Page 32)

32 >> Loudspeaker setup – surround sound
Calibrate the sound level
When you have connected speakers in a
surround sound setup to the television, you
must perform a speaker calibration.
A calibration sound is produced alternately in
each of the speakers you have connected in
your surround sound setup. Your task is to
adjust the sound level from all the connected
speakers to match the sound level from the
centre speaker. You can choose whether you
want the sound sequence to occur
automatically or manually.
Once you have performed your speaker
calibration, you will only need to re-calibrate
the speaker sound if you make changes to the
setup, for example, if you move one or more
of the speakers.
To calibrate the sound level …
> Press MENU to bring up the TV SETUP menu
and press to highlight SOUND.
> Press GO to bring up the SOUND menu and
press to highlight SPEAKER LEVEL.
> Press GO to bring up the SPEAKER LEVEL menu.
SEQUENCE is highlighted.
> Press or to choose between AUTOMATIC
and MANUAL.
> Press or to adjust the speaker sound and
or to move to another speaker.
> When you have adjusted the sound for all the
speakers in your surround sound setup, press
GO to store or press EXIT to leave the menu
without storing.
It is not necessary to calibrate subwoofer sound in
a surround sound setup.
SPEAKER LEVEL
store GO
SEQUENCE AUTOMATIC
LEFT FRONT . . . . . . . .
RIGHT FRONT . . . . . . . .
RIGHT REAR . . . . . . . .
LEFT REAR . . . . . . . .