Bang & Olufsen BeoVision 8-40 User Guide (pre Aug 2010) - Manual (Page 28)

28
If you connect additional video
equipment to your television, you
must register the equipment in the
CONNECTIONS menu.
When the system is first set up, the
equipment connected at that
particular moment is detected by the
television, and the CONNECTIONS
menu appears automatically on the
screen. If you connect equipment at
a later date, on a permanent basis,
then you must register this
equipment in the CONNECTIONS
menu.
For information about where and
how to connect extra equipment,
refer to the previous pages and the
chapter ‘Connection panels’ on page
50.
Register additional video equipment
What is connected?
Registering the equipment connected to the
television enables you to activate it with the
Beo4 remote control.
> Press TV to switch on the television.
> Press MENU to bring up the TV SETUP menu.
> Press to highlight CONNECTIONS.
> Press
GO to bring up the CONNECTIONS menu.
> Press or to step between the different
socket groups: AV1, AV2, AV3 and possibly AV4.
> Press GO to be able to register a connected
product to the highlighted socket group.
> Press or to move between sockets in the
group.
> Press or to register what you have
connected to the highlighted socket.
> Press GO to be able to select another socket
group.
> Press STOP to back up through previous menus
or press EXIT to exit all menus directly.
If you register a source to a socket and do not assign
an IR socket to this source, a sub-menu opens
where you must choose between, for example,
Bang & Olufsen and Non-Bang & Olufsen products.
AV2
store GO
SOURCE V. MEM
IR SOCKET NONE
HDMI NONE
YPbPr NO
S/P-DIF NONE