English, Information, Set up your television – Bang & Olufsen BeoVision 12 (Wall Bracket) User Manual
Page 8: Run cables, Connections, Overview
Information
– for more information:
Sockets on the connection panel
Mains cord and plug
The connection panel on the back of the TV contains the sockets for connection to the BeoSystem 4 and
connection to the mains supply.
The supplied plug and mains cord are specially designed for the product. Do not change the plug and if the
mains cord is damaged, you must buy a new one from your Bang & Olufsen retailer.
Set up your television
This Guide contains information about the connection and setting-up of your TV
with a Bang & Olufsen BeoSystem 4. For general information on daily operation,
see the BeoSystem 4 guides, available oe
expect your retailer to deliver, install and set up your product.
Run cables
When the TV is mounted on the wall bracket, you
can push down the distance bracket (A) to access
the connection panel.
Connections
Make the connections while both the TV and your
BeoSystem are disconnected from the mains.
Connect the TV using the appropriate type of
cables. When all connections are made, connect
your whole system to the mains supply. Your TV
has an integrated centre speaker. To enhance the
sound experience, you can connect additional
speakers.
Overview
1 Indicator light. When the TV is switched on or
off the indicator light lights up briefly. For more
information, see the BeoSystem 4 guides,
available on www.bang-olufsen.com/guides.
2 IR-blasters sending 3D signals.
3 IR-receiver for receiving the remote control signals.
4 Sensor arm for Automatic Colour Management.
For safety reasons, secure the cables with cable
strips. Place the cables behind the distance bracket.
1
2
2
3
4
POWER LINK
POWER LINK
HDMI IN
POWER LINK
IR OUT
HDMI OUT
PL6
IR / AUTO
CONTRAST
CONTRO
L
MONITOR
CONTRO
L
BEOSYSTEM
BEOSYSTEM
A
8