Toshiba DynaPad WT12PE-A64 - Manual (Page 124)

124 If Something Goes Wrong
Display problems
Perform a system restore
You can perform a system restore to a period in time at
which the touchpad was working properly.
If no restore points have been previously created then
this method will not work, see
“Saving system
configuration with restore points” on page 144 .
1 In the Search field on the taskbar, type Create a
restore point .
2 Click or touch Create a restore point .
3 Select the System Restore button on the System
protection tab.
4 Select Recommended Restore or Choose a
different restore point to restore the system to a point
at which your touchpad was working properly.
Adjust the touchpad properties
1 In the Search field, type Change your mouse
settings .
2 Click or touch Change your mouse settings .
Some devices may have an Advanced tab (or similar)
to change the touchpad properties.
3 You can now change the configuration settings of your
touchpad.
Display problems
Here are some typical display problems and their solutions:
The screen is blank.
Display Auto Off may have gone into effect. Press any key or
touch anywhere on the screen activate it.
If you are using the built-in screen, make sure the display
priority is not set for an external monitor. To do this, press the
(
) key or open the Action Center ( ), see “Directing the
display output (no optional keyboard dock attached)” on
page 56
. If this does not correct the problem, press the ( )
key or open the Action Center ( ) again to return the
display priority to its previous setting.
NOTE
NOTE