Lanner LEC-2220 - Manual (Page 23)

23
Hardware Setup
Chapter 4
Embedded and Industrial Computing
Wall Mounting
The product ships with wall mounting kit. To mount your
product on the wall, follow the instructions below:
First make a hole for the anchor in the surface on the 1.
wall. Use the following diagram as a guideline for
placing the anchors.
Then press the anchor into the hole until it is flush with
2.
the surface. You may need a hammer to tap the wall
anchor.
Use a screwdriver to screw the threaded screw into the
3.
plastic anchor.
Attach the wall mounting bracket to the back of the
4.
device, securing it in place with four of the flat-head
screws provided.
Hang the device on the wall.
5.
On 2220P2 with 2 PCI slot
Note: Using a PCIe or PCI riser card, users have
choice of either PCI or PCI Express 1x expansion:
1x PCI or 1xPCIe can be supported by model 1.
LEC-2220P
2x PCI can be supported by model LEC- 2.
2220P2
Both PCI or PCIe support the Max. 3.
Dimension as the following illustrated and
the Max. Power consumption reserved for
expansion is 25W in total.
Connecting Power
Connect the LEC-2220 to a +9~+30V DC-in power source.
The DC power-in connector comes with a 2-pin terminal
block for its Phoenix contact. This power socket can only
accept the power supply with the right pin contact so be
cautious when inserting power to the system.
Unit: mm
+ -
dC IN
4
5