Lanner LEC-2220 - Manual (Page 22)

22
Hardware Setup
Chapter 4
Embedded and Industrial Computing
Installing the Hard Disk
The system can accommodate one Serial-ATA disk. Follow
these steps to install a hard disk into the system:
Take out the hard disk tray and fix the hard disk on 1.
the tray with 4 mounting screws as illustrated in the
following picture.
Plug the Serial-ATA cable to the hard disk.
2.
Place the hard disk back to the system’s chassis and fix 3.
it with the mounting screws.
Connect the Serial-ATA power and data disk cables to
4.
the Serial-ATA power and disk connectors on the main
board respectively.
PCI/PCIe Riser Card Installation
The system can accommodate one PCI or PCIe expansion
(two PCI or PCIe expansion on model P2) module. In order
the install the PCI or PCIe expansion module, a low-profile
riser card has to be installed first. Follow these steps to
install the riser card:
Fix the riser card on the bracket with 3 screws. 1.
Install the riser card on the system by connecting the 2.
connectors with the system’s PCIPCIE connector.
Fix the riser card on the board.
3.
Connect the PCIe expansion card to the riser. 4.
Fix the card holder to the system 5.
On 2220P with one PCIe slot
1 2
3
4
1
2
3
4
5