Lanner LEC-2136 - Manual (Page 16)

16
Hardware Setup
Chapter 4
Embedded and Industrial Computing
Chapter 4:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first.
WARNING: To reduce the risk of personal injury,
electric shock, or damage to the equipment,
remove the power cord to remove power from the
server. The front panel Power On/Standby button
does not completely shut off system power.
Portions of the power supply and some internal
circuitry remain active until AC power is removed.
Unpower the LEC-2136 and remove the power cord. 1.
Unscrew the 4 rubber feet from the bottom of the LEC- 2.
2136 System.
Open the cover upwards. 3.
System Memory Installation
The motherboard supports DDR3 memory. It comes with
one Double Data Rate type three (DDR3) Small Outline
Dual Inline Memory Modules (SO-DIMM) sockets.
Align the SO-DIMM connector key with the SO-DIMM 1.
socket key.
Install the SO-DIMM. 2.
Note:
The motherboards can support up to 4 GB 1.
memory capacity in maximum.
Hard Disk Installation
The system can accommodate one Serial-ATA disk. Follow
these steps to install a hard disk into the LEC-2136:
Align the hard disk with the mounting holes on the 1.
chassis cover.
Secure the hard disk with 4 mounting screws on the
2.
cover from the outside.
Connect the Serial-ATA cable to the hard disk.
3.
Plug the Serial-ATA cable to the Serial-ATA drive and 4.
power connectors on the main board.
Put the hard disk tray with the installed hard disk back
5.
to the system and secure it with the mounting screws.
1
2