Lanner LEC-2026 - Manual (Page 34)

LEC-2026
34
(Device, Vendor, Size, LBA Mode, Block Mode, PIO Mode, Async DMA, Ultra DMA,
and SMART monitoring). These values are not user-configurable.
These items show N/A if no IDE device is installed in the system.
Hard disk boot priority: When press enter, then will display screen as below: Select
boot sequence for on board (or add-on cards) SCSI, RAID, etc.
Type: Selects the type of IDE drive. Setting to Auto allows automatic selection of
the appropriate IDE device type. Select CDROM if you are specifically configuring a
CD-ROM drive. Select ARMD (ATAPI Removable Media Device)
if your device is either a ZIP, LS-120, or MO drive.
Configuration options: [Not Installed] [Auto] [CDROM] [ARMD]
LBA/Large Mode: Enables or disables the LBA mode. Setting to Auto enables the
LBA mode if the device supports this mode, and if the device was not previously
formatted with LBA mode disabled.
Configuration options: [Disabled] [Auto].
Block (Multi-sector Transfer): Enables or disables data multi-sectors transfers.
When set to Auto, the data transfer from and to the device occurs multiple sectors
at a time if the device supports multi-sector transfer feature. When set to
[Disabled], the data transfer from and to the device occurs one sector at a time.
Configuration options: [Disabled] [Auto].
PIO Mode: Selects the PIO mode,
Configuration options: [Auto] [0] [1] [2] [3] [4].
DMA Mode: Selects the DMA mode.
Configuration options: [Auto] [DMA0][SWDMA1] [SWDMA2] [MWDMA0]
[MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2] [UDMA3] [UDMA4] [UDMA5].
SMART Monitoring: Sets the Smart Monitoring, Analysis, and Reporting
Technology. Configuration options: [Auto] [Disabled] [Enabled].
32Bit Data Transfer: Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled].
Hard Die Write Protect: The device write protection. This will be effective only if