Lanner Digital Input/Output - Manual (Page 23)

Software User Manual Version 1.0
21
D-IN: Check the box to alter the voltage level of the digital input pins as to enable or
disable the input pins. The default value for D-in is 1 which indicates the high voltage
(5V).
The corresponding commands:
Winbond W83627UHG SuperI/O:
The index address is 2EH.
Fintek F81865 SuperI/O Chip:
The index address is 2EH.
Note: Refer to Appendix A for more
information on the Register (page 150 of
W83627 datasheet) Note: Refer to Appendix B for more
information on the Register (page
87-101 of F81865 datasheet)
D-Out: Check the box to alter the voltage level of the digital output pins as to write the
output pins to “1”. The default value for D-Out is 0 which indicates the low voltage (0V).
Winbond W83627UHG SuperI/O:
The index address is 2EH.
Fintek F81865 SuperI/O Chip:
The index address is 2EH.
Note: Refer to Appendix A for more
information on the Register (page 150 of
W83627 datasheet) Note: Refer to Appendix B for more
information on the Register (page
87-101 of F81865 datasheet)
PIO:
The PIO is the programmable input/output. In Lanner products, they are provided as
additional LED indicators for certain events which can be defined in your software.
Winbond W83627UHG superI/O:
The index address is 2EH.
Fintek F81865 SuperI/O Chip:
The index address is 2EH.
Note: Refer to Appendix A for more
information on Register (page 150 of
W83627 datasheet) Note: Refer to Appendix B for more
information on Register (page
87-101 of F81865 datasheet)